CARQON Flatbed Manuel page 32

5.8 Error code display
The flatbed system's components are continuously and automatically monitored. If an error is detected,
the corresponding error code is displayed on the on-board computer. The drive may be automatically shut
down, depending on the type of error. However, if you wish to continue cycling, you will always be able to
do so without assistance from the drive. Check the full Bosch manual or bosch-ebike.com for all the possible
error codes.
Code Reason
410 One or more buttons of the on-
board computer are disabled.
414 Operating unit connection
problem.
430 Internal battery of the onboard
computer is flat.
503 Speed sensor fault.
592 Incompatible component.
605 Battery temperature error.
620 Charger fault.
6 Brakes
Adapt your driving and speed to the weather and road conditions. In wet conditions the performance of the
brakes may reduce and the braking distance may increase. If you operate the front brake too heavy, this may lead
to somersaulting. Therefore, we strongly advise you to brake simultaneously via the left-hand and right-hand levers.
Use the left brake lever for the front wheel carefully at high speed.
●
Adapt the braking force to the riding situation.
●
Always brake simultaneously with both brakes.
●
Use the rear brake with care.
●
Incorrect brake pads may lead to reduced or increased brake performance or to brake failure.
●
Only replace brake components with original spare parts.
●
Carqon is equipped with two disk brakes which take independent effect on the front wheel and the rear
●
wheel. Over a short braking distance, brake evenly with both brakes.
Warning: If you notice that the effect of the brake is low, have the brake
system checked by a Carqon dealer.
32
Corrective measures
Check whether any buttons are stuck, e.g. as a result of dirt
finding its way in. Clean the buttons if need be.
Have the connections checked.
Charge the on-board computer (in the holder or via the
USB port).
Restart the system. If the problem persists, contact your
Carqon dealer.
Use a compatible display. If the problem persists,
contact your Carqon dealer.
The e-bike is outside of the permissible temperature range.
Switch off the system and allow the drive unit to either cool
down or heat up to the permissible temperature range.
Restart the system. If the problem persists, contact your
Carqon dealer.
Replace the charger. Contact your Carqon dealer.