Nederman Fan Start Stop Device Manuel De L'utilisateur page 16

EN NOTE!
A network power switch is recommended for
the electrical system including the fan.
4.5 Program the receiver
Program the receiver to find only one transmitter. Ad-
ditional transmitters will be automatically linked to
the system. To link transmitters to the receiver, see
Section 3.1 Main components,
and follow the procedure below:
1 Connect the power supply to only one transmitter
that is to be linked to the receiver. All other trans-
mitters must be switched off. See
LEDs (item 4), LED 9 (item 12) and LED 10 (item 7)
are lit.
NOTE!
If the power to the transmitter is less than
6V, its LED will be lit (red). The power is
weak, but the transmitter can still send a
signal to the receiver as long as the voltage
is greater than 5V.
2 Press button F once. Power LEDs (item 4) and pro-
gramming LED 11 (item 12) are lit.
3 Press button S once. The relay function LEDs
(5,1,2,3,4) (item 6 and 7), flash three times when
the receiver has found the transmitter.
4 Relay function LED 1 (item 7) is lit.
NOTE!
Power LED 1 remain lit until power is dis-
connected from the transmitter, or the re-
ceiver loses contact with the transmitter.
16
Fan Start Stop Device
Figure 1 and Figure 2,
Figure 1. Power
4.6 Reset the receiver
See Section 3.1 Main components,
ure 2, and follow the procedure below:
1 Press button F once.
2 Press and hold button S until the function relay
LEDs (5,1,2,3,4) are not lit.
The system is now unlinked, and no transmitters work
with the receiver. See Section 4.5 Program the receiv-
er to re-link the receiver to the transmitters.
4.7 Installation check
Follow the procedure below to check the installation.
See also Figure 1 and Figure
1 Start a vehicle.
2 Check that the transmitter LED for that vehicle
is lit (green). See Figure
power to that transmitter is weak; less than 6V.
3 Check that the fan starts.
4 The fan stops approximately 2,5 minutes after the
following:
• The vehicle's engine is turned off.
• The receiver loses contact with the transmitter.
NOTE!
If the fan does not stop, make sure all vehicles
are off and that no transmitter is receiving
power, or at least that the power to transmit-
ters is less than 1V.
5 Maintenance
Check the system at least once a month. See
tion 4.7 Installation check.
Figure 1 and Fig-
2:
2. If the LED is lit (red),
Sec-