Nederman Fan Start Stop Device Manuel De L'utilisateur page 14

1 Preface
EN
Thank you for using a Nederman product!
The Nederman Group is a world-leading supplier and
developer of products and solutions for the environ-
mental technology sector. Our innovative products
will filter, clean and recycle in the most demanding of
environments. Nederman's products and solutions will
help you improve your productivity, reduce costs and
also reduce the impact on the environment from in-
dustrial processes.
Read all product documentation and the product iden-
tification plate carefully before installation, use, and
service of this product. Replace documentation imme-
diately if lost. Nederman reserves the right, without
previous notice, to modify and improve its products
including documentation.
This product is designed to meet the requirements
of relevant EC directives. To maintain this status, all
installation, maintenance, and repair is to be done
by qualified personnel using only Nederman original
spare parts and accessories. Contact the nearest au-
thorized distributor or Nederman for advice on tech-
nical service and obtaining spare parts. If there are
any damaged or missing parts when the product is de-
livered, notify the carrier and the local Nederman rep-
resentative immediately.
2 Safety
2.1 Classification of important informa-
tion
This document contains important information that
is presented either as a warning, caution or note, ac-
cording to the following examples:
WARNING! Risk of personal injury
Warnings indicate a potential hazard to the
health and safety of personnel, and how that
hazard may be avoided.
14
Fan Start Stop Device
CAUTION! Risk of equipment damage
Cautions indicate a potential hazard to the
product but not to personnel, and how that
hazard may be avoided.
NOTE!
Notes contain other information that is import-
ant for personnel.
3 Description
This start/stop device is specially designed for use to-
gether with Nederman exhaust extraction systems
such as MagnaTrack, MagnaStack, MagnaRail, Pneu-
matic Track or Pneumatic Rail System.
3.1 Main components
Receiver, see
1 Power supply input
2 Stop relay
3 Relay for exhaust fan
4 Power supply LED (yellow)
5 Bridge connector
6 Stop relay LED (red)
7 Relay function LEDs (1, 2, 3, 4) (red)
8 Internal antenna
9 Programming connector
10 Function button
11 PLs status LED (red)
12 Function LEDs (8, 9, 10, 11) (red, yellow, green, or-
ange)
13 Select button
Transmitter, see
1 LED (green or red)
2 Black wire, negative (-)
3 Red wire, positive (+)
Figure 1:
Figure 2: