Beko RH08122T Mode D'emploi page 14

4 Operation
[Timing On]
Under Off state, press the
remote controller
the timing enquiry interface, the setting
time and timing icon
knob to adjust the setting time, it will au-
tomatically exit the enquiry setting inter-
face if it is not operated within 3s. When
the setting is 0, it cancels Timing On.
After reaching the Timing On time, the
heater automatically turns on and works
at the last standby state. The time set-
ting range is 0-24H, the adjustment unit
in hour.
[Timing Off]
Under On state, press the
remote controller
into the timing enquiry interface, turn
the knob to adjust the setting time, it will
automatically exit the enquiry setting
interface if it is not operated within 3s.
When the setting is 0, it cancels Timing
Off. After reaching the Timing Off time,
the heater automatically enters into the
standby state and stops work. The time
setting range is 0-24H, the adjustment
unit in hour.
[Remote and ]
When working mode is on, press the
button on control panel, press " " or " "
to adjust temperature within 5°C to 35°C.
Press the button on remote controller,
press " " or " " to adjust time within O to
24 hours.
14 / EN
button (or
button) to enter into
flashed, turn the
button (or
button) to enter
[Introduction on mode]
Normal mode : under this mode, the
heater works at the setting level, af-
ter reaching the setting temperature, it
stops heating and the setting tempera-
ture flashes.
Energy saving mode ECO: under this
mode, the heater works normally, the lev-
el and setting temperature are not adjust-
able, the heater works at default setting
temperature (22°C). (In Energy saving
mode, if the setting temperature flashes,
it means the heater is under energy sav-
ing heat preservation work state). The in-
dicator light circle indicates green.
Anti-Freezing mode
press the knob to adjust the level, but the
setting temperature is not adjustable,
the heater works at default anti-freez-
ing temperature (5°C). (In Anti Freezing
mode, if the setting temperature flashes,
it means the heater is under anti-freezing
heat preservation work state). The indi-
cator light circle indicates red.
[Memory Function]
When the power of the heater is not cut
off or the heater keeps under Standby
mode, it can memorize the last work-
ing mode and setting temperature and
works at the setting temperature after
turning on, the memory data will be re-
set if the power supply of the heater is
cut off, and the setting temperature of
the heater recovers to the default setting
(Normal mode, high, setting temperature
is 35°C) when turning on.
Oil Filled Heater / User Manual
: under this mode,