Beko RH08122T Mode D'emploi page 13

4 Operation
Power on the heater, press the Power
switch at the lower side to On position,
the power indicator lights on and buzzer
makes sound to enter into the standby
mode.
[On/Off]
Under Standby mode, press the
(or remote controller
er enters into the Normal mode, works
with highest power, and automatically
set the temperature at 35°C, or recover
to the state of the last standby state
(Note: when the power is not cut off).
Repeatedly press the knob untill the
heater recovers to the Standby state.
[Mode switch]
Under Working State, press the button
M, the heater switches between Low
-- Middle-- High--Fast Heating Mode --
Energy Saving Mode -- Anti-Freezing
Mode -- Low. Orrepeatedly press the
remote controller button
between Normal Mode -- Fast-Heating
Mode -- Energy Saving Mode -- Anti-
Freezing Mode -- Normal Mode.
Oil Filled Heater / User Manual
Temperature
Mode
Temperature
Timing
Temperature control
Indicator light circle
On/Off
knob
button), the heat-
to switch
Mode
increase
decrease
[Level switch]
Under Working State, press the button
M, the heater switches between Low
- Middle-- High - Fast Heating Mode --
Energy Saving Mode -- Anti-Freezing
Mode -- Low.
Or under normal mode, repeatedly press
the remote controller button
between High
(orange) -- Middle (red) -- Low (green) --
High (orange).
[Temperature setting]
Under Normal mode, press the
to check the current setting temperature,
and the temperature icon flashes. Turn
the knob to adjust the setting tempera-
ture, it will automatically exit the enquiry
setting interface if it is not operated with-
in 3s, and display the setting tempera-
ture.
On/Off button
Timer button
Mode button
to switch
button
13 / EN