Schildkröt 3238208 Manuel Utilisateur page 4

Please read this user manual to ensure optimal and safe use of the product. Product and user manual are conform to standard EN 14619
(Class A). Assembly by adults only. This product is intended for private use only. It is not suitable for commercial use.
Specifications
Article:
Article number:
Dimensions:
Maximum user weight:
Read and follow the user manual and any other information before assembling and using the product. Failure to observe can
cause serious or even fatal injuries. The user manual is an integral part of the product.
When giving the product to third parties, please make sure to hand over this user manual as well. For the safety of your children, it is your
responsibility to read these information together with your child to ensure your child understands all warnings, safety information, and user
instructions. We strongly recommend checking the scooter's condition and the knowledge of your child from time to time and to frequently
review all warnings and safety information with your child.
Supervise children during use and never let them ride alone in traffic!
Safety information
- Observe all applicable traffic rules and regulations regarding the use of scooters in your country.
- Only one person may use this scooter at any given time.
- Use this scooter on suitable grounds that are flat, clean, dry, and ideally without the presence of other road users.
Wet, slippery and uneven surfaces may affect the traction of the wheels, thereby causing accidents and falls. Do not ride through mud,
water or puddles. Do not ride on roads covered with ice or snow.
- Wear personal protective equipment. Never ride without helmet, hand/wrist protection, elbow protection, or knee protection.
- Before starting: Check all connectors or fasteners for integrity and stability (e.g. the folding mechanism and the correct height of the
handlebar).
- Make sure the kickstand (if existent) is always folded when riding.
- Avoid sloping terrain or steep grounds.
- Always wear suitable shoes (never ride without shoes or with sandals or shoes that do not allow for firm, secure stance).
- Do not ride during darkness and/or under conditions of poor visibility.
- Always be aware of pedestrians and other road users. Always show consideration for others.
- This scooter is not suitable for performing jumps or stunts.
Installation
- The scooter is folded during transportation (fig. 1).
- Open the quick-release skewer located on the right front above the footboard by pulling the lever, causing the transport safety lock to
disengage (fig. 2).
- Then raise the black plastic lever in the center of the folding mechanism until the locking mechanism disengages. Fold the
steering rod to the front until the locking screw of the quick-release skewer securely clicks into its respective groove at the front (fig. 3).
- Lock the quick-release skewer on the right (fig. 4). If not tight enough open the fastener again and tighten the opposite nut for the
complete quick-release skewer to sit more tightly on the folding mechanism. Repeat these steps until the folding mechanism is fixed
without play.
- Remove the handlebar from the packaging. Now open the handlebar clamp at the upper end of the steering tube by loosening
the two Allen screws (fig.5). Now put the handlebar on and align it in the center (note the marking). Then fasten the upper part
of the handlebar clamp by evenly tightening both Allen screws (fig.6). Finally, check that the handlebar is inserted correctly and firmly.
- Adjusting the height of the steering rod: Loosen the quick-release skewer on the top of the handlebar shaft by pressing the lever away
from the shaft (fig. 7).
- The height of the handlebar can be adjusted to 3 different positions. To do so pull the steering rod off the shaft until the desired height
is reached and the locking knob clicks into its respective hole (fig. 8).
- Then close the quick-release skewer by pushing the lever back to the handlebar shaft. If the handlebar is not fully secured at the chosen
position open the skewer again and tighten the opposite nut for the quick-release skewer to sit more tightly on the shaft. Repeat these
steps until the handlebar shaft is fixed securely without play (fig. 9).
WARNING: Never exceed the safeguard of the upper pullout height (last lock-in point on the upper end of the handlebar shaft).
-
The knob for locking the steering rod must always be secured by one of the 3 lock-in points; otherwise the height adjustment is not
properly completed. Using the scooter under such condition is dangerous and therefore not permitted!
- Make sure the handlebar shaft is always positioned with the logo facing forward towards the direction of riding (the holes for locking
the height positions face backwards in such a case).
Before riding the scooter, check all connecting parts and quick-release skewer for proper fixation.
-
- To fold the scooter (transportation condition) proceed as follows:
Thank you for choosing this SCHILDKRÖT scooter.
Schildkröt City Scooter STREET PRO
510020
Length: 104 cm, Height max.: 101 cm, Footboard (dist. between neck & break): 40 x14 cm, Weight: 5.2 kg
100 kg
5
EN