Publicité
Les langues disponibles
Les langues disponibles
3
Installation
The serial plate is located under
the cooktop. When ordering parts
C
for or making inquiries about your
cooktop, always be sure to include
the model and serial numbers and a
lot number or letter from the serial
plate on your cooktop.
• Ensure that there is a distance of 2" between
the hob and the wall or sides.
• Ideally the hob should be installed with plenty
of space on either side. There may be a wall at
the rear and tall units or a wall at one side. On
the other side, however, no unit or divider must
stand higher than the hob.
• The piece of furniture or the support in which
the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue
used to fix them, must be able to resist temper-
atures of up to 212 °F.
• The mural rods of edge must be heat-resisting.
• Not to install the hob to the top of a not venti-
lated oven or a dishwasher.
• To guarantee under the bottom of the hob cas-
ing a space of 1" to ensure a good air circulation
of the electronic device.
• If a drawer is placed under the work, avoid to put
into this drawer flammable objects (for example:
sprays) or not heat-resistant objects.
Induction Hob / User Manual
• Materials which are often used to make work-
tops expand on contact with water. To protect
the cut out edge, apply a coat of varnish or
special sealant. Particular care must be given
to applying the adhesive joint supplied with the
hob to prevent any leakage into the supporting
furniture. This gasket guaranties a correct seal
when used in conjunction with smooth work top
surfaces.
• The safety gap between the hob and the cooker
hood placed above must respect the indications
of the hood manufacturer. In case of absence of
instructions respect a distance minimum of 29
15/16".
• The connection cord should be subjected, after
building, with no mechanical constraint, such for
example of the fact of the drawer.
3.4Electricalconnection
• The installation of this appliance and the con-
nection to the electrical network should be
entrusted only to an electrician perfectly to the
fact of the normative regulations and which re-
spects them scrupulously.
• The electrical parts should always be protected
after the installation.
• The appliance should be connected using a
multipolar circuit breaker.
• If the appliance is not fitted with an accessible
plug, disconnecting means must be incorpo-
rated in the fixed installation, in accordance with
the installation regulations.
• The inlet hose must be positioned so that it does
not touch any of the hot parts of the cooktop or
oven.
Caution! This appliance must only
B
be connected to a network 220-
240 V~ 50/60 Hz. Always connect
the ground wire
11 / EN
Publicité
