Publicité
• Move the flow control lever (2) as far as it will go to
the "OFF" position. Push the feed plate back as far as it
will go to the closed position. See figure 11.
• Place the bent end of the flow control link (44) into
the feed plate bracket and a 1/4" flat washer (37). Secure
it with a 3/32" x 3/4" cotter pin (24). See figure 11.
• Tighten the lower 1/4" nylock hex nut (26) until it
touches the bottom of the ferrule, then tighten the upper
1/4" nylock hex nut (26) until it is snug against the top of
the ferrule. See figure 11.
•
Open and close the feed plate using the flow
control lever. Check to make sure the feed plate is
closed completely when the lever is in the "OFF"
position. If the feed plate does not close completely,
adjust the 1/4" nylock hex nuts (26) on the flow
control link (44). See figure 11.
NOTE: Forcing the flow control lever
may result in PERMANENT DAMAGE to
the feed plate!
26
26
44
FEED PLATE
FIGURE 11
2
24
37
• Push a flanged bearing (22) into each side of the drive
disk (8). See figure 12.
8
22
FIGURE 12
• Push a flanged bearing (22) into each of the eight
spike disks (7), from the side shown in figure 13.
7
FIGURE 13
• Press flanged bearings (22) into both of the end plates.
See figure 14.
• Place the 1/4" thick spacer (40) onto the spike disk
shaft (12) and then insert the shaft through the flanged
bearing (22) in the left hand end plate. See figure 14.
22
FIGURE 14
9
22
22
22
40
12
Publicité
