Home Decorators Collection SARINA CF1004B Guide D'utilisation Et D'entretien page 9

Assembly - Hanging the Fan (continued)
5
Install the canopy
□
Align two key holes of canopy (C) with the pre-installed
screws under the mounting bracket (A). Push up the canopy (C)
until the screws heads engage to the key holes
on the canopy (C), and rotate the canopy (C) counterclockwise
until it is attached to the bottom of the mounting bracket (A)
tightly. Figure 1.
□
Tighten two preinstalled screws to secure the canopy
(C) to the mounting bracket (A) using hex key (FF). Figure 2.
A
C
Figure 1
FF
6
Mounting the remote wall cradle
NOTE: The remote wall cradle is designed to allow you to access an
existing switch. The remote wall cradle can be mounted on the wall
or to the face plate of a standard toggle switch or a paddle switch.
Follow the instructions below for the option that best suits your needs.
1a. Attaching over a standard toggle switch
□
Remove the two screws from the toggle switch face plate.
□
Place the toggle switch spacer over the toggle switch face plate
and align the two large holes of the toggle switch spacer with the
holes in the face plate. Secure the toggle switch spacer to the face
plate using the two included machine screws (JJ).
□
Attach the remote wall cradle (H) to the toggle switch spacer using
the included two short tapered screws (II). Screw a short tapered
screw (II) into the top hole and bottom hole of the wall cradle and
into the toggle switch spacer until tight.
1b. Attaching over a paddle switch
□
Remove the two screws from the paddle switch face plate.
□
Place the remote wall cradle (H) over the paddle switch and align
the two holes of the remote wall cradle (H) with the holes in the
face plate. Secure the remote wall cradle (H) to the face plate
using the two included machine screws (JJ).
1c. Attaching to the drywall
NOTE: Screw drywall anchors(GG) are included for extra support.
The included screws are designed to screw easily into the wall. If
you would like a more permanent or secure hold, install the drywall
anchors(GG) prior to attaching the wall cradle to the wall.
□
Position the remote wall cradle (H) in the desired position and
attach to the wall using the included two long tapered screws(HH).
Figure 1a
H
Figure 1b
9
Please contact 1-800-986-3460 for further assistance.
JJ
II
H
HH
JJ
HH
Figure 1c
HOMEDEPOT.CA
H