Bosch DCU 100 Consignes D'utilisation page 19

4. Commissioning
¶
Remove the DCU 100, the battery, the power supply
unit with power cord and the DVD drive with USB
connecting cable from the case.
4.1 Fitting battery
¶
Insert the battery in the battery compartment and
secure by means of the two screws on the battery
(see Fig. 3, Pos. 3).
i
It is advisable to charge the battery for at least three
hours before running the DCU 100 off the battery.
4.2 Connection
Prior to commissioning, make sure the mains voltage
coincides with the voltage specified on the power
supply unit (use the power cord provided).
4.3 Operating system configuration
1. Supply the DCU 100 with power by way of the power
supply unit.
2. Switch on the DCU 100.
3. After switching on for the first time, use the
language selection menu to select the Windows
operating system language and follow the instruc-
tions on the screen.
i
There is no provision for subsequent alteration of
the Windows operating system language. Should
this nevertheless become necessary, the language
selection menu can be re-started under "Start >> All
Programs >> Tools >> Localization".
4.4 Software installation
i
During a software installation always supply the
DCU 100 with voltage via the power supply unit.
i
See the installation instructions provided with the
respective software for additional information con-
cerning installation and update of the software.
Robert Bosch GmbH
All manuals and user guides at all-guides.com
5.
5.1
!
1. Switch on the DCU 100 by pressing the On/Off
2. Use the pen to touch the application required.
5.2
Weitergabe sowie Vervielfältigung der Zeich-
nungen sind nicht gestattet und müssen
streng vertraulich behandelt werden. Alle (
Rechte sind bei ads-tec GmbH nach DIN 34.
strictly confidential according to DIN 34. File:Airbag Lenkrad + TT13 Doku 130
1. Press the function key ƒ.
2. Select <Shutdown> in the start menu.
"
i
i
5.3
The menu "Start >> Control panel >> Power options"
can be used to select and alter the power saver plan
(e.g. the monitor switch-off time or the display bright-
ness setting).
Commissioning | DCU 100 | 19
Operation
Switch-on
To avoid the formation of condensation, allow the
DCU 100 to adjust to ambient temperature before
switching on the DCU 100.
button .
 Following run-up of the Windows operating
system the start mask appears.
CAUTION – Risk of injury from triggering of
airbag with DCU 100 hanging from steering
wheel.
If the DCU 100 is attached to (suspended
from) the steering wheel, injuries could re-
sult from unintentional airbag triggering.
¶
Never attach the DCU 100 to the steering
wheel.
Switch-off
Rz 10
)
Druckdatum/ print date: 17.12.2010
 The start menu and task bar are opened.
 Windows is shut down.
The DCU 100 is switched off.
Pressing the On/Off button
down the Windows operating system and switches
off the DCU 100.
Pressing the On/Off button
switches off the DCU 100 without first shutting
down the operating system. This mode should only
be used if shutdown of the Windows operating sys-
tem is not possible.
Setting power options
en
for > 2 seconds shuts
for > 12 seconds
|
1 689 989 174 2015-03-25