Publicité
Les langues disponibles
Les langues disponibles
EN
USER GUIDE
•
Take off the packaging: Take the machine out of the packaging, get rid of
the poly bags and the protection EPE strips in the slots of the anti-collision
panels.
•
Install the side brushes: Take the two side brushes from the packaging, fit
the square hole of each brush base to each of the two square convex of
the machine bottom and press it to position. After pressing, pull the brush
slightly to check if the brush is easily pulled off the square convex, in which
case the brush is not pressed to position and needs fixing again.
•
Charging: Using the AC adapter with Type-C power cord provided along with
the machine to charge the machine, also you can use the Type-C power cord of
your mobile phone, make sure the output of the adapter plug is 5V/2A. Insert the
Type-C into the charging inlet and the adapter plug into the local power outlet,
the machine is under charging, the lights will start flashsing when need charging,
and once the charging is completed, the lights will turn green.
Attention: Charging shall be done in room temperatue, overheating or
overcooling may lead to longer charging time or even damage the battery.
•
Mop: According to the actual need of cleaning, you can decide to use or not
use the mop. If you decide to use mop, please first make the mop wet, but
ensure no water dripping, then stick the white side of the mop to the magic
stickers on the bottom panel.
Attention: Prevented the mop from hiding the suction port or touching the two
driving wheels.
•
Start using the machine: Put the machine on the floor with the wheels down to
the ground, press ON/OFF button once to start the machine, the LED indicators
turns green. If the LED indicators start flashing, it is low battery, please charge the
machine fully before next cleaning. When the cleaning is completed, press ON/
OFF button again to stop the machine.
MAINTENANCE AND CLEANING
•
Cleaning the machine
Before cleaning, make sure the power is off and the power cord for charging
is taken off. Use clean water with a little neutral detergent to wet a clean cloth,
twist it to a state of no water dripping, then use the wet cloth to clean the outer
and inner surfaces of the machine. After cleaning, open the top panel to let the
machine air dry.
Attention: Do not use gasoline or corrosive liquid to clean the machine. Wet cloth
with water dripping may lead to water leakage to the electrical compartment and
damage the machine.
6
Publicité
