Festool WTS 150/7 E Notice D'utilisation D'origine page 9

Eccentric sander
Technical data
Power
Speed
Sanding stroke
Weight (excluding cable)
Degree of protection
The specifi ed illustrations can be found at the
beginning of the operating instructions.
Symbols
Warning of general danger
Wear a dust mask!
Wear protective goggles!
Read the Operating Instructions/Notes!
Wear ear protection!
1 Intended use
As specifi ed, the machines are designed for sand-
ing and polishing wood, plastic, metal, stone,
composite materials, paint/varnish, filler and
similar materials. Materials containing asbestos
must not be processed. For reasons of electrical
safety the machine must not be damp nor oper-
ated in a humid environment. The machine may
only be used for dry sanding.
The user is liable for damage and injury
resulting from incorrect usage!
2 Safety instructions
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fi re
and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
- Harmful/toxic dusts can occur during your work
(e.g. lead-containing paint, some types of wood
and metal). Contact with these dusts, espe-
cially inhaling them, can represent a hazard for
operating personnel or persons in the vicinity.
Comply with the safety regulations that apply in
WTS 150/7 E your country. Connect the electric power tool to
500 W a suitable extraction system.
2000 - 6000 rpm
7 mm
1.9 kg
/ II
- The manufacturer's handling and processing
instructions must be observed without fail if
explosive or self-igniting dusts are likely to oc-
cur during sanding.
- Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated
residual current of 30 mA or less.
- If the power tool is dropped or falls, check
for damage to the machine and sanding pad.
Remove the sanding pad for closer inspection.
Repair damaged parts before using again. Bro-
ken sanding pads and damaged machines can
cause injuries and machine instability.
3
The typical values determined in accordance with
EN 60745 are:
Sound pressure level
Sound-power level
Measuring uncertainty allowance
Overall vibration levels a
rections) measured in accordance with EN 60745:
Handle
Auxiliary handle
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– they represent the primary applications of the
power tool.
Increase possible for other applications, with oth-
er insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!
4
To switch on, push the switch (1.3) forwards until
it engages. Pressing the back end of the switch is
9
To protect your health, wear a P2 protec-
tive mask.
Always wear protective goggles because
of possible dangers when sanding.
Noise and vibration information
Wear ear protection!
(vector sum for three di-
h
Power supply and start-up
The mains voltage must correspond to
the specifi cation on the rating plate.
82 dB(A)
93 dB(A)
K = 3 dB
a = 4,5 m/s²
h
K = 2,0 m/s²
a = 6,5 m/s²
h
K = 2,0 m/s²