Movement instruction
Hold the sides of the bottom of the product, then lift and move. Since
the machine is heavy, please handle it with care to avoid back strain.
(This machine must be carried by two or more people)
1.Please lift up the massage chair to move on vulnerable ground such
as wooden floors.
2.When moving on a similar wooden floor, it is recommended to lift it
up. To prevent the casters from damaging the floor, please lift the
product and move it to the designated position. Be careful not to crush
your feet when putting down the product. Do not let go of the unit until
the unit is completely leveled, as the floor may be damaged, so it is
recommended to place mats, etc. on the floor.
10
Method of movement
Use the rear casters to move the massage chair. As shown in the
picture, tilt the chair about 45° backward and forward to move it.
Note: Do not press down too much to prevent the chair from falling
completely and causing damage to the product.
1.Before moving, it must be turned off correctly, so that the backrest
and calf mechanism are completely reset, and then the power supply
of the product is released.
2.The product should be left empty when moving. People, pets or
sundries should not be allowed to stay on the product.
3.Do not use casters to move across obstacles higher than 2mm or
gaps larger than 5mm.
4.When using casters to move this product, please try to avoid
continuous use over a distance of 164ft; if you need to use it for a long
distance, please push slowly to avoid wear on the casters.
11