ADJ NET 8 Mode D'emploi page 8

R E A R C O N N E C T I O N S
AC CONNECTIONS
The NET 8 is rated for 100-240V 50/60Hz, and accepts AC mains power within that range. Do not
connect it to power outside this range. Note that the device uses a T1.25A/250V fuse. Damage resulting
from incorrect connection is not covered under warranty. A cable with a NEMA 15-5P plug is provided
for use with the NET 8 in the USA and Canada. This approved cable must be used in North America.
DMX CONNECTIONS:
All DMX Output connections are 5pin female XLR; however, the pin-out on all sockets is pin 1 to
shield, pin 2 to cold (-), and pin 3 to hot (+). Pins 4 and 5 are not used. Carefully connect DMX cables
to the respective ports. To prevent damaging the DMX ports, provide strain relief and support. Avoid
connecting FOH Snakes to the ports directly.
Pin Connection
1 Com
2 Data -
3 Data +
4 Not connected
5 Not connected
ETHERNET DATA CONNECTION
The Ethernet cable is connected on the back of the router into the port labeled A or B. Devices can be
daisy chained, but it is recommended not to exceed 10 NET 8 devices in one chain. Although this is an
Locking RJ45 Ethernet connector, and the use of Locking RJ45 Ethernet cables is recommended, any
RJ45 connector is suitable.
The Ethernet connection is also used to connect a computer to the NET 8 for remote configuration via
a web browser. To access the web interface, simply enter the IP address shown in the display in any
web browser connected to the device. Information about the web access can be found in the manual.
8