ADJ NET 8 Mode D'emploi page 6

S A F E T Y G U I D E L I N E S
This device is a sophisticated piece of electronic equipment. To guarantee a smooth operation, it is important to
follow all instructions and guidelines in this manual. ADJ PRODUCTS, LLC. is not responsible for injury and/or
damages resulting from the misuse of this device due to the disregard of the information printed in this manual.
Only the original included parts and/or accessories for this device should be used. Any modifications to the
device, included and/or accessories will void the original manufactures warranty and increase the risk of damage
and/or personal injury.
PROTECTION CLASS 1 - FIXTURE MUST BE PROPERLY GROUNDED
THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT.
DO NOT ATTEMPT ANY REPAIRS YOURSELF; DOING SO WILL VOID YOUR MANUFACTURER'S
WARRANTY. DAMAGES RESULTING FROM MODIFICATIONS TO THIS FIXTURE AND/OR
THE DISREGARD OF SAFETY INSTRUCTIONS AND GUIDELINES IN THIS MANUAL VOID
THE MANUFACTURE'S WARRANTY AND ARE NOT SUBJECT TO ANY WARRANTY CLAIMS
AND/OR REPAIRS.
DO NOT PLUG FIXTURE INTO A DIMMER PACK!
NEVER OPEN THIS FIXTURE WHILE IN USE!
UNPLUG POWER BEFORE SERVICING FIXTURE!
NEVER TOUCH FIXTURE DURING OPERATION, AS IT MAY BE HOT!
KEEP FLAMMABLE MATERIALS AWAY FROM FIXTURE!
INDOOR / DRY LOCATIONS USE ONLY!
DO NOT EXPOSE FIXTURE TO RAIN AND MOISTURE!
DO NOT shake the device; avoid brute force when installing and/or operating the device.
DO NOT operate the device if the power cord is frayed, crimped, damaged, and/or if any of the power
cord connectors are damaged and do not insert into the fixture securely with ease.
NEVER force a power cord connector into the device. If the power cord or any of its connectors are
damaged, replace it immediately with a new one of a similar power rating.
When installing the fixture in a suspended environment, always use mounting hardware that is no less
than M10 x 25 mm, and always install the fixture with an appropriately rated safety cable.
Always disconnect the fixture from the main power source before performing any type of service and/
or cleaning procedure.
Only handle the power cord by the plug end; never pull out the plug by tugging the wire portion of the
cord.
During the initial operation of this fixture, light smoke or a smell may emit from the interior of the fixture.
This is a normal process and is caused by excess paint in the interior of the casing burning off from the
heat associated with the lamp and will decrease gradually over time.
Consistent operational breaks will ensure the fixture functions properly for many years.
ONLY Use the original packaging and materials to transport the fixture for service.
6