Festina Mademoiselle Manuel D'instruction page 3

I
ENGLISH INSTRUCTION MANUAL
A) DISPLAY AND BUTTON
day ( of the week )
second hand
NORMAL CROWN POSITION
1ST POSITION - QUICK OPERATION - DATE (COUNTERCLOCKWISE)
2ND POSITION - TIME/DAY SETTING (CLOCKWISE)
B) OPERATION PROCEDURE
1. SETTING THE DAY
SETTING THE TIME (HOUR, 24HOUR, MINUTE and SECOND)
2. SETTING THE DATE
C) SETTING THE DAY AND TIME (HOUR, 24 HOUR, MINUTE AND SECOND)
The hour, 24 hour, minute, second and day are set by the same operation.
SETTING PROCEDURE
DAY
C-1) SETTING THE DAY
1. Pull the crown out to the 2nd position to stop the second hand at 0 (12 o'clock).
2. Turn the hour/minute hands in a clockwise direction to set a day.
3. In order to set the day, you must advance the hour hand by 24 hours per day.
* If the day is set by turning the crown counterclockwise, there is the possibility the date will not change over.
Do not set the day by turning the crown in counterclockwise direction.
* The day changes somewhere between 0:00a.m. and 5:30a.m. or a little later.
C-2) SETTING THE TIME
After setting the day, set the hour (and 24hour) and minute hands.
1. Turn the hour/minute hands in a clockwise direction to set the time.
2. To ensure time is set accurately, first turn the minute hand 5 minutes ahead of desired time and then turn back (in a
counterclockwise) to the desired time.
3. After setting the time, use a time signal to synchronize the watch by pushing crown to the normal position to start the second
hand going.
* Make sure you have correctly set AM/PM before setting the time.
* When the day changes over, it is a.m.. (Day changes over between 0:00a.m. and 5:30a.m. or little later).
Check am./p.m. by the 24hour hand.
E) SETTING THE DATE (BY QUICK OPERATION)
Pull the crown out to the 1st position. Turn the crown counterclockwise to set the date quickly.
* Do not set the date between the hours 9:00p.m. and 0:30a.m.. The date may not change correctly the next day.
By virtue of the regulations pursuant to the handling of waste products deriving from electronic and electrical equipment, end of lifecycle watch making
products must be selectively collected for processing. You may therefore dispose of your quartz watch making products at any of our retail outlets or any other
authorized collection point. The selective collection, processing, rating and recycling of these products helps contribute to safeguarding the environment and
protecting our health.
minute hand
hour hand
HOUR & 24HOUR
IFM6P29/79
normal crown position
24hour hand
SECOND
MINUTE
1st position
2nd position
date