Publicité
Les langues disponibles
Les langues disponibles
EN
8.1.6 Connection of Shield Gas .
Connect the gas tube of the bottle outlet
regulator to the equipment inlet connector (9).
Be sure to make all connections firmly to avoid
gas leaks and thus be able to start welding in a
protected manner.
WARNING!!!.
Please keep in mind:
1. Protective gas leak affects welding performance.
2. Avoid exposing the gas bottle to the direct action
of the sun's rays and thus avoid a possible
explosion of the bottle due to the increasing
pressure of the gas caused by heat.
3. Protective gas leak affects welding performance.
4. Avoid exposing the gas bottle to the direct action
of the sun's rays and thus avoid a possible
explosion of the bottle due to the increasing
pressure of the gas caused by heat.
5. Place the bottle vertically on a stable surface
avoiding the risk of accidental fall.
6. Never hit the gas bottle or place it horizontally.
7. Ensure that no person is near the regulator, before
releasing the gas or closing the outlet.
8. The gas outlet flow meter must be installed
vertically to ensure accurate measurement.
9. Before connecting the gas regulator to the
equipment, open and close the gas passage several
times to eliminate possible dust in the filter and
ensure the correct gas flow.
10. Since the arc of the MIG weld is much stronger
than that of the MMA weld, wear a welding
helmet and protective clothing.
63
Publicité
