Publicité
Les langues disponibles
Les langues disponibles
EN
7. TECHNICAL SPECIFICATIONS.
(*) Note: The welding duty cycle is the percentage of actual continuous welding time that can occur in a ten
minutes cycle. For example: 20% at 200amps- this means the welder can weld continuously at 200 amps for
2 minutes and then the unit will need to be rested for 8 minutes.
The duty cycle can be affected by the environment in which the welder is used. In areas with temperatures
exceeding 40℃, the duty cycle will be less than stated. In areas less than 40 ℃, higher duty cycles have
been obtained
All tests on duty cycles have been carried out at 40℃ with a 50%. So in practical working conditions the
duty cycles will be much greater than those stated above.
8. INSTALLATION AND START UP.
8.1. MIG/MAG welding process.
8.1.1 Fitting the spool
8.1.1.1 open the cover door for the wire feed compartment. Remove the wire spool retainer (18) by
threading off anti clockwise.
8.1.1.2 fit the 200mm diameter wire spool to the spool holder, ensuring the end of the wires exits towards
the wire feeder from the bottom of the spool. Refit the wire spool retainer (18) and tighten finger tight.
61
Publicité
