Publicité
Les langues disponibles
Les langues disponibles
EN
• Do not alter or misuse the machine. This machine was built with accuracy. Any alteration or
modification not specified is a misuse and can lead to dangerous situations.
• The use of an appropriate safety device, such as a thermal and differential switch, is
recommended when using electrical equipment.
5.5. REPAIR.
• The repair of the machine must be carried out only by qualified staff. Repair or maintenance
performed by an unqualified person can lead to risk of injury.
• Only the spare parts or accessories recommended by the manufacturer should be used for the
maintenance of the machine. Follow the instructions in the maintenance section of this manual.
The use of unauthorized parts or failure to follow maintenance instructions may result in the risk
of electric shock or injury.
6. SPECIFIC SAFETY RULES FOR WELDING MACHINES.
6.1. THERMAL PROTECTION.
The equipment is protected against thermal overloads via an automatic recharge thermostat. When
the set maximum temperature is reached, the protection will cut off the power circuit current and the
WARNING display 1 will be shown. DO NOT TURN OFF OR DISCONNECT THE EQUIPMENT WHILE THE
THERMAL PROTECTION IS ACTIVE, AS DOING SO MAY CAUSE SERIOUS DAMAGE TO THE MACHINE.
After a few minutes, the warning light will go out and the power will come back. The equipment will
then be ready to resume operation.
6.2. PROTECTION AGAINST OVERLOAD.
The equipment is protected against the voltage or current peaks caused by the power supply to which
it is connected (public network, generator, etc.), if it occurs, the welding current will be interrupted and
the WARNING! display 2 will be shown. Follow ther instructions.
equipment only following the
procedure
manual.
dangerous for people, animals
and things.
The user of the welder is
responsible for his own safety
and that of others: it is key to
read, understand and align with
the basic rules contained in this
manual. Make sure that the
current absorption and the
protection of the electric line
correspond to those of the
machine and the outlet.
58
CAUTION:
Use
the
provided
in this
Misuse
can
be
Publicité
