EINHELL TC-BD 630/1 Instructions D'origine page 19

•
Pillar drill
•
Chuck
•
Folding chip guard
•
Original operating instructions
•
Safety instructions
3. Proper use
This pillar drill is designed for drilling metal, plas-
tic, wood and similar materials. It is intended for
use in the private sector only.
Food and harmful materials are not allowed to be
processed with the machine. The drill chuck is de-
signed for use only with drill bits and tools with a
shaft diameter of 1.5 to 16 mm, and for cylindrical
tool shanks. Tools with a tapered shank can also
be used. The equipment is intended for use by
adults only
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Rated input voltage .................220-240 V~ 50 Hz
Power rating ............................. 630 W S2 15 min
Motor speed ........................................1400 min
Output speed .............................. 250-2400 min
Drill chuck mount ......................................... B 16
Scroll chuck ....................................Ø 1.5-16 mm
Reach .................................................... 126 mm
Dimensions of drill table ................ 195 x 200 mm
Table angle adjustment ................... 45° / 0° / 45°
Drilling depth ............................................ 60 mm
Pillar diameter .......................................... 60 mm
Height .................................................... 850 mm
Base area ..................................... 220 x 400 mm
Weight ......................................................20.1 kg
Anl_TC-BD_630-1_SPK13.indb 19 Anl_TC-BD_630-1_SPK13.indb 19
GB
A load factor of S2 15 min (intermittent periodic
duty) means that you are allowed to operate the
motor continuously at its nominal power level (630
W) for no longer than the time stipulated on the
specifi cations label (15 min). If you fail to observe
this time limit the motor will overheat. During the
break in operation the motor will cool again to its
starting temperature.
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 12717.
L sound pressure level ........................ 69 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 82 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for.
-1
-1
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
- 19 -
18.01.2023 11:21:36 18.01.2023 11:21:36