Publicité
3.3.1 INSTALLING NON-COMBUSTIBLE BOARD
THE SURFACE ABOVE THE APPLIANCE GETS VERY HOT. IF PROPER FINISHING MATERIALS
LA SURFACE AU-DESSUS DE L'APPAREIL EST TRÈS CHAUDE. SI DES MATERIAUX DE
FINITION CORRESPONDANTS NE SONT PAS UTILISES, DES RISQUES PEUVENT
The 11" (279.5mm) above the appliance must not be finished with any combustible materials. If only a
painted surface is desired, a full single sheet of cement board should be used.
The manufacturer supplies only the minimum sized board required.
NOTE: To minimize joints, it may be best to replace the supplied non-combustible board with a larger piece.
INSTALLING WITH PAINTED SURFACE ONLY. TOP OF FIREBOX
TOP OF FIREBOX
WARNING
ARE NOT USED, CRACKING CAN OCCUR.
Joint Compound where required:
Compounds such as Durabond 90 and tapes that are heat and
cracking resilient should be used when taping and mudding
seams.
Setting tiles and grouting:
If using tiles we recommend you use tiles with a dry butt joint to
be installed using a two part mortar with an acrylic latex additive,
to allow for slight movement in the normal operation of the
appliance. If grout is used between the tiles we recommend a
polymer-based grout.
Primer/Paint:
For a painted surface, use a 100% acrylic latex primer and finish
coat.
NOTE: Light coloured surfaces may discolour due to heat.
TO CEILING
RECOMMENDED REPLACEMENT CEMENT BOARD IF
TO CEILING AND WIDTH OF WALL
SURVENIR.
SUPPLIED NON-COMBUSTIBLE
BOARD 2 PIECES 11" (279.5mm)
HIGH x 35.4" (899.16mm) WIDE
Page 17 of 53
Publicité
