Kenwood KMR-M508DAB Guide De Démarrage Rapide page 14

4 Rub the film antenna gently onto the
windscreen in the direction of the arrow
shown to allow it to stick firmly.
5
Remove the separator (tag 2) of film
antenna (F) vertically.
Separator (tag 2)
6
6 Set the position of the protrusion of the
amplifier unit (G) with the K mark on the
film antenna (F) and paste.
Do not touch the lead terminal or the pasting
surface (adhesive side) of the amplifier unit
(G).
• When installing the antenna on the right
side
Earth sheet
Lead terminal of the
film antenna (F)
Lead contact of the amplifier unit
(metal part)
• When installing the antenna on the left side
Earth sheet
7 Remove the film covering the earth sheet
and paste the earth sheet on the metal part
of the vehicle.
Provide sufficient leeway for the earth sheet
so that it does not interfere with the interior
parts (front pillar cover). Also take care that
the interior parts do not interfere with the
amplifier unit (G).
Set the position of
the protrusion with
K mark
Front pillar cover
8
Wire the antenna cables.
Use cable clamper (H) to secure the antenna
to the pillar at several positions.
9 Attach the front pillar cover back to its
original position.
Be sure not to damage the earth sheet and
amplifier unit (G) when covering.
10
Connect the amplifier unit (G) to the DAB
antenna jack on the rear of the unit.
Note:
Make sure [DAB ANT POWER] is set to [ON] on the
[FUNCTION] menu in standby mode.
[ON] is selected initially.
Windscreen
Earth sheet
(G)