Bosch BCS210 Notice D'utilisation page 14

English – 12
state of charge can be displayed for 3 seconds by
pressing the on/off button (10) on the eBike battery.
Disconnect the charger from the mains and the eBike
battery or the eBike from the charger.
The eBike and eBike battery switch off automatically
after being disconnected from the charger.
Note: If you have charged the battery on the eBike,
carefully close the charging socket (6) with the
WARNING
Do not open any of the components. Service
u
should only be carried out at an authorized
Bosch eBike dealer. Failure to follow above warn-
ing can cause death or serious injury. Refer to your
bicycle manual or component manual for all non-
Bosch drive system components.
Do not apply any cleaning agents, paint or chem-
u
icals to any components of the Bosch drive sys-
tem as they may cause premature failure of the
component.
After-sales service and advice on using
products
If you have any questions about the eBike and its
components, contact an authorized bicycle retailer.
For contact details of authorized bike dealerships,
please visit www.bosch-ebike.com.
More information about the eBike compo-
nents and their functions can be found in
the Bosch eBike Help Center.
0 275 U07 XCX | (14.03.2024)
cover (7) after charging, so that no dirt or water can
get in.
If the charger is not disconnected from the eBike bat-
tery after charging, after a few hours the charger will
switch itself back on, check the state of charge of the
eBike battery and begin the charging procedure again
if necessary.
Maintenance/cleaning
Bosch eBike Systems