Bosch BCS210 Notice D'utilisation page 13

(5) Charging connector
(6) Socket for charging connector
(7) Charging socket cover
(8) Rack-mounted battery
(5)
(5) Charging connector
(6) Socket for charging connector
(7) Charging socket cover
Switch the eBike battery off. Clean the cover of the
charging socket (7). Avoid getting moisture and dirt,
e.g. sand or soil, in the charging socket and contacts.
Lift the cover of the charging socket (7) and plug the
charging connector (5) into the charging socket (6).
There is a risk of fire due to the charger heating
u
up during charging. Ensure the eBike battery on
the eBike is completely dry and placed on a fire-
proof surface before charging. When doing so,
Bosch eBike Systems
(8) (6)
(7)
(5)
(6) (7)
read and observe the operating instructions of the
eBike battery.
Charging Process for Two eBike Batteries
If two eBike batteries are fitted to an eBike, both
eBike batteries can be charged using the uncovered
connection. To begin with, both eBike batteries are
charged one after the other until they reach ap-
prox. 80–90 % capacity, then they are both fully
charged at the same time (the LEDs flash on both
eBike batteries).
When the bike is in operation, power is drawn from
both eBike batteries on an alternating basis.
If you take the eBike batteries out of the holders, you
can charge each one individually.
Charging process
The charging process begins as soon as the charger is
connected to the eBike battery or charging socket on
the eBike and to the mains.
Note: The charging process is only possible when the
temperature of the eBike battery is within the permit-
ted charging temperature range.
Note: The drive unit is deactivated during the charg-
ing process.
The eBike battery can be charged with and without
the on-board computer. When charging without the
on-board computer, the charging procedure can be
observed on the eBike battery charge indicator.
When the on-board computer is connected, a charg-
ing notification appears on the display.
The state of charge is displayed by the battery charge
indicator (9) on the eBike battery and by the bars on
the on-board computer.
The LEDs on the eBike battery charge indicator (9)
flash during the charging process. Each solid illumi-
nated LED represents approximately 20 % of the
charging capacity. The flashing LED indicates the next
20 % currently charging.
Once the eBike battery is fully charged, the LEDs ex-
tinguish immediately and the on-board computer is
switched off. The charging process is terminated. The
English – 11
0 275 U07 XCX | (14.03.2024)