Troubleshooting; Declaration Of Conformity - B+BTec Diamond3 3510RS Manuel D'utilisation

DIAMOND3

troubleshootIng

Problem
The machine
doesn't start.
Water doesn't flow
at the blade but the
pump is running.
Motor isn't running
smoothly.
Pump isn't running.
Cutting out of align-
ment.
declArAtIon of
conformIty
We declare under our sole responsibility
that this product is in conformity with the
following standards or standardization
documents.
98/392/EEC, 91/368/EEC,
93/44/EEC, 93/68/EEC,
89/336/EEC, 92/31/EEC,
73/23/EEC
3510/15RS - 4015RS
®
Cause
The power supply cable is
damaged or not properly con-
nected.
No voltage in the power outlet.
Start switch is damaged.
The sprayers are clogged.
The water level in the water bin
is not sufficient. The pump is not
totally submerged.
Water valve is closed.
Water may have seeped
through inside the motor.
Capacitor is damaged.
Damaged motor bearing.
The impeller or suction filter of
the pump is damaged.
No proper connection of the
power cable.
Machine is not leveled out.
Unstable working surface.
Improper or glazed diamond
blade.
Solution
Press the plug firmly in the power
outlet. Check the power supply
cable.
Have the power outlet checked.
Have the switch replaced.
Clean the sprayers.
Fill the water bin with clean
water until the pump is totally
submerged.
Open the valve.
Unplug the power cable and
consult your local dealer.
Replace damaged parts.
Have the connection checked.
Loosen the screws for the legs.
Pick up the machine a little bit on
one end. Let the machine down
again and tighten screws. Per-
form the same procedure on the
other end. The machine should
now be leveled out.
Make sure the machine is placed
on a leveled surface.
Replace or dress the diamond
blade.
02
Subject to change without notice.
For spare parts or advice contact
B+BTec
Munterij 8
4762 AH Zevenbergen
The Netherlands
+31 168 331 260
info@bbtectools.com
19
GB