Safety; Maintenance; Environmental Protection - B+BTec Diamond3 3510RS Manuel D'utilisation

GB DIAMOND3
close to the saw blade.
• Switch the machine on and pull the
saw head with medium force with the
other hand through the material.

sAfety

Besides the valid safety regulations atten-
tion to the following items should be made:
• Carefully follow the directions of set-
ting up and working with the sawing
machine.
• Carefully check that the electrical con-
nections are correct.
• Electrical cables should not come in
contact with water or water spray.
• Damaged saw blades should be
replaced immediately.
• Secure material to be cut by hand dur-
ing sawing.
• Make sure your hands stay away as
far as possible from the rotating saw
blade.
• Wear protective goggles during saw-
ing.
• Wear hearing protection during saw-
ing.

mAIntenAnce

• The cooling water should be replaced
and/or replenished regularly.
• It is recommended to clean the water
container, pump, hoses and spray noz-
zle on a regular basis. For example,
place the pomp in a bucket of clean
water after the sawing job and run the
machine for a minute or so. This also
guarantees a longer lifetime of the
pump.
• When the machine is not used for a
longer period, the pump should not
remain in the muddy cooling water.
Cleaning the pump as described
above and leaving it outside the water
3510/15RS - 4015RS
®
container is better.
• Regularly check the saw flanges for
wearing out and replace if necessary.
Diamond blade dressing
Diamond blades performs best when they
are dressed.
After time and use, diamonds on the outer
edge of the blade might become glazed
or dull. This will reduce cutting efficiency
and possibly cause the blade to bend.
As a result the cut will not be straight and
mis-aligned. When this occurs, the blade
needs to be dressed.
The diamond blade can be dressed with a
dressing stick.
Dressing procedure(s):
• Place a dressing stick on the saw table
• Make approx. 10 cuts through the
dressing stick.
The diamond blade should be sharp again
and ready for further efficient cutting.
envIronmentAl
protectIon
management organisation. Adhere also to
the applicable regulations. In case of
doubt refer to your waste management
organisation. Recycle all packaging mate-
rial in an environmentally friendly manner.
18
Do not dispose of the appliance
with domestic waste. Dispose of
the appliance only via an author-
ized waste management com-
pany or your municipal waste