Mitsubishi Electric MSZ-GS12NA Notice D'utilisation page 55

W
EEKLY TIMER OPERATION
3
Press , , and
temperature.
Pressing
selects ON/OFF timer.
Pressing
adjusts the time.
Pressing
deletes timer setting.
* Hold down the button to change the time quickly.
* The temperature can be set between 61°F and 88°F (16°C and 31°C) at
weekly timer.
Press and
other days and/or numbers.
4
Press to complete and transmit the weekly timer
setting.
Note:
• Press to transmit the setting information of weekly timer to the indoor
unit. Point the remote controller toward the indoor unit for 3 seconds.
• When setting the timer for more than one day of the week or one number,
does not have to be pressed per each setting. Press
after all the settings are complete. All the weekly timer settings will be saved.
• Press to enter the weekly timer setting mode, and press and hold
for 5 seconds to erase all weekly timer settings. Point the remote
controller toward the indoor unit.
5
Press to turn the weekly timer ON. (
* When the weekly timer is ON, the day of the week whose timer setting
is complete, will light.
Press again to turn the weekly timer OFF. (
goes out.)
Note:
The saved settings will not be cleared when the weekly timer is turned OFF.
to set ON/OFF, time, and
E.g. : [ON], [AM 6:00]
and [75°F
(24°C)] are
selected.
Pressing
adjusts the tem-
perature.
to continue setting the timer for
* which was blink-
ing goes out, and the
current time will be
displayed.
lights.)
6
Put the remote controller in places where its signal
always reaches the indoor unit.
• The signal is transmitted from the remote controller at the set time.
• If the indoor unit cannot receive the signal at this time, it does not
operate according to the setting on the weekly timer. Therefore, note
the position of the remote controller.
* Weekly timer is controlled by the
remote controller.
Note:
The signal from the remote controller becomes weaker when the batteries are
running low.
Checking weekly timer setting
1
Press to enter the weekly timer setting mode.
* blinks.
2
Press or
day or number.
once
Press
Note:
When all days of the week are selected to view the settings and a different set-
ting is included among them,
to view the setting of the particular
to exit the weekly timer setting.
will be displayed.
En-10