Mitsubishi Electric MSZ-GS12NA Notice D'utilisation page 10

● OPERATING INSTRUCTIONS ●
W
EEKLY TIMER OPERATION
• A maximum of 4 ON or OFF timers can be set for individual days of the week.
• A maximum of 28 ON or OFF timers can be set for a week.
E.g. : Runs at 75°F (24°C) from waking up to leaving home, and runs at 81°F
(27°C) from getting home to going to bed on weekdays.
Runs at 81°F (27°C) from waking up late to going bed early on week-
ends.
Setting1 Setting2
Mon
ON OFF
75°F (24°C)
Fri
AM 6:00 AM 8:30
Setting1
Sat
ON
Sun
AM 8:00
Note:
The simple ON/OFF timer setting is available while the weekly timer is on. In this case,
the ON/OFF timer has priority over the weekly timer; the weekly timer operation will start
again after the simple ON/OFF timer is complete.
Setting the weekly timer
* Make sure that the current time and day are set correctly.
1
Press to enter the weekly timer setting mode.
En-9
Setting3 Setting4
ON OFF
81°F (27°C)
PM 5:30 PM 10:00
Setting2
OFF
81°F (27°C)
PM 9:00
* blinks.
2
Press and to select setting day and number
Pressing selects the day of the
week to be set.
* All days can be selected.
3
Press , , and
temperature.
Pressing
selects ON/OFF timer.
Pressing
adjusts the time.
Pressing
deletes timer setting.
* Hold down the button to change the time quickly.
* The temperature can be set between 61°F and 88°F (16°C and 31°C) at
weekly timer.
Press and to continue setting the timer for
other days and/or numbers.
4
Press to complete and transmit the weekly timer
setting.
Note:
• Press to transmit the setting information of weekly timer to the indoor unit.
Point the remote controller toward the indoor unit for 3 seconds.
• When setting the timer for more than one day of the week or one number,
does not have to be pressed per each setting. Press
tings are complete. All the weekly timer settings will be saved.
• Press to enter the weekly timer setting mode, and press and hold
for 5 seconds to erase all weekly timer settings. Point the remote controller toward
the indoor unit.
.
E.g. : [Mon Tue ... Sun] and
[1] are selected.
Pressing selects
the setting number.
to set ON/OFF, time, and
E.g. : [ON], [AM 6:00]
and [75°F
(24°C)] are
selected.
Pressing
adjusts the tempera-
ture.
* which was
blinking goes out, and
the current time will be
displayed.
once after all the set-