Publicité
Les langues disponibles
Les langues disponibles
Getting started
D
Drying
Sensor cycles automatically determine fabric dryness.
Cycles
Timed cycles run for the selected time.
TIMED DRY
Use to set your own dry time. To use:
1. Turn cycle dial to TIMED DRY.
2. Increase the drying time by pressing the Time pad.
NOTE: This pad only increases the time. When max time is reached, pressing the pad again
will reset the counter to the lowest setting.
3. Select the Temp.
4. Close the door.
5. Press Start/Pause pad.
Settings
E
Individual settings for cycle minutes (Time), dryness level (Level) and temperature (Temp) can be set from the
minimum (lowest in column) to maximum (highest in column). In general, the higher up the column, the more
energy will be used. NOTE: The selected cycle set Time can be further adjusted, in one minute increments, by
pressing the More Time + and Less Time - pads.
Dryness Level - Selection only used for Sensor cycles. Timed cycles run for the selected time.
NOTE: Options for Dryness Levels vary by model. Refer to the control panel on your model or to the control
panels shown earlier in this manual.
Extra Dry
Use for heavy-duty fabrics or items that should be very dry, such as towels.
More Dry
Use for heavy-duty or mixed type fabrics.
Dry
Use for a normal dryness level suitable for most loads. This is the preferred cycle for energy
savings.
Less Dry
Use for lighter fabrics.
Damp
For leaving items partially damp.
Temperature
High
For regular to heavy cottons.
NOTE: STEAM Dewrinkle and STEAM Refresh require the High temperature setting.
Medium
For synthetics, blends, delicates and items labeled permanent press.
Low
For delicates, synthetics and items labeled tumble dry low.
Extra Low
For lingerie and special-care fabrics.
No Heat
For fluffing items without heat. For use only with the AIR FLUFF cycle.
49-3000206 Rev 3
9
Publicité
