Baxtran BR70 Manuel D'usager page 24

User's Guide
ACCUMULATED TOTAL
The scale can be set to accumulate manually by pressing the
method using function "F5 PRT". The accumulation function is only available when weighing. It is disabled during parts counting.
The weight displayed will be stored in memory when the
The display will show "ACC 1" and then the total in memory for 2 seconds before returning to normal. If the optional RS232 interface is
installed the weight will be output to a printer or PC.
Remove the weight, allowing the scale to return to zero and put a second weight on. Press the
and then the new total.
Continue until all weights have been added.
To view the totals in memory press
recall display.
When the scales are set to display in other units of weight the accumulation function is still keeping the weight in kilograms.
6. PARAMETERS
The scale has 6 parameters that can be set by the user plus a method of entering the calibration section.
To set parameters press the
The display will show the first function, "F0 H-L".
Pressing the
Pressing key will allow you to set the function. It may be necessary to either use
key to move the active digit and then using the
leave a parameter unchanged.
For example when the display shows "F0 H-L" press the
The display will show "Set Lo", press the
setting the high limit.
After pressing the
the flashing digit. Continue to the next digit and set it as needed.
When all digits have been set press the
Advance to another parameter if needed or press the
24
key in zero point (ZERO indicator on), to clear the memory, just press
key.
key will cycle through the other functions.
key to set a limit, use the
key to store the value. The display will go back to the parameter just set, i.e. "Set Lo".
Indicator
. key. See the PARAMETERS Section for details of selecting the
key is pressed and the weight is stable.
key to increment a digit, followed by the
key to begin.
key to set the low limit, or press the
key and keys to change the flashing digit, then use the
key to return to weighing.
Model BR70
key, the display will show "ACC 2"
key during memory
or set a value using the
key to enter the value. Use the key to
key to skip to the next parameter, "Set Hi" for
key and
key to increment