Publicité
Les langues disponibles
Les langues disponibles
User's Guide
1. SPECIFICATIONS
2. INSTALLATION
› The weighing indicator should be sited in location that will not degrade the accuracy.
› Avoid extremes of temperatures. Do not place in direct sunlight or near air conditioning vents.
› Avoid unsuitable table. The tables or floor must be rigid and not vibrate. Do not place near vibrating machinery.
› Avoid unstable power sources. Do not use near large users of electricity such as welding equipment or large motors.
› Avoid high humidity that might cause condensation. Avoid direct contact with water. Do not spray or immerse the scale in water.
› Keep the weighing indicator clean.
› Verify the voltage showing on the label matches the voltage in your area.
› Attach the mains cable to the connector on the side of the indicator. The power switch is located next to the mains inlet.
› Load cell connect as below (9 pin D-sub connecter).
20
model
resolution
stabilisation time
operating temperature
power supply (externe)
calibration
display
indicator housing
zero range
signal input range
ADC
internal counts
ADC update
load cell drive voltage
load cells
dimensions
Indicator
BR70
1/15.000
1 seconds typical
0ºC - 40ºC / 32ºF - 104ºF
110/240 Vac, 50/60Hz
automatic external
6 digits of 24 mm / LCD with backlight
ABS plastic
0mV ~ 5mV
0 ~ 15mV
Sigma delta
600.000
Max 60 times/second
Max 5V/150mA
up to four 350 ohms cells
280x160x170 mm
Model BR70
Publicité
