Kenwood kMix HM800 Serie Instructions page 4

before using your Kenwood appliance
Read these instructions carefully and retain for future
●
reference.
Remove all packaging and any labels.
●
safety
Ensure the cord is fully unwound from the cord wrap
●
before using the handmixer.
Never put the handmixer body in water or let the cord
●
or plug get wet.
Keep fingers, hair, clothing and utensils away from
●
moving parts.
Never let the cord touch hot surfaces or hang down
●
where a child could grab it.
Never use a damaged handmixer. Get it checked or
●
repaired: see 'service and customer care'.
Never use an unauthorised attachment.
●
Always unplug the appliance when not in use, before
●
fitting or removing parts or before cleaning.
This appliance is not intended for use by persons
●
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do
●
not play with the appliance.
Only use the appliance for its intended domestic use.
●
Kenwood will not accept any liability if the appliance is
subject to improper use, or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is the same as the
●
one shown on the underside of your handmixer.
This appliance conforms to EC directive 2004/108/EC
●
on Electromagnetic Compatibility and EC regulation no.
1935/2004 of 27/10/2004 on materials intended for
contact with food.
before using your handmixer for the first time
Wash the parts (see 'cleaning').
●
key
speed switch
tool release button
beaters
cord wrap
kneader with additional collar
kneader without additional collar
beater storage pillars
kneader storage pillars
worktop storage unit
cord clip
to use your handmixer
1 Unwrap the cord from the cord wrap and make sure
the speed switch is in the off position by lining up the O
symbol on the handmixer body with the dot on the side
of the speed switch. Insert the beaters or kneaders –
turn and push until a positive click is felt. The tabs on
the tool shafts need to line up with the outlet holes.
Important: The kneader with the additional collar will
only fit into the larger outlet hole.
2 Plug in.
3 With the ingredients in a suitably sized bowl, place the
beaters/kneaders into the bowl.
4 Pull the speed switch backwards to reach the desired
speed (the first dot on the handmixer body is slow and
speed 5 is fast). Line up the dot on the side of the
speed switch with the corresponding speed.
As the mixture thickens, increase the speed.
●
If the machine labours increase the speed.
●
Move the speed switch forwards to the pulse position
●
(P) to operate the motor as required. The motor will
operate for as long as the pulse is held in position.
5 When the mixture has reached the desired
consistency, return the speed switch to the off
position and then lift the beaters/kneaders out of the
bowl.
6 To remove the tools, make sure the speed switch is in
the off position and unplug the handmixer. Press the
tool release button. Hold onto the tool shafts when
ejecting the tools.
Important:
When making bread dough we recommend that the
●
dough load does not exceed 400g flour.
With heavy mixtures, such as dough, don't use your
●
handmixer for longer than 3 minutes in any 5 minute
period as the protection device might operate.
Switch it off as soon as you've got the right
consistency.
2