Fimar Forcold 1410TN Mode D'emploi page 5

Fitting the Waste Water Tray
The waste water tray comes ready to fit to the underside of the appliance. Slide the tray into the runners situated under the
appliance.
Fittlng the Shelves
1. Piace one set of shelf guides on either side of the cabinet at the desired height.
2.Slide the shelf into piace.
tor the remaining shelves.
3. Repeat
<D Note: Thls 1s vttal tor ensurlng corree! dralnage of condensatlon.
Operation
Storing Food
T o gel the best resulls trom your appliance, foliow these instructions:
Only store toodstuffs in the appliance when it has reached the corree! operating temperature.
Do not piace uncovered hot food or liquid inside the appliance.
Wrap or cover food where possible.
Do noi obstruct the fans inside the appliance.
Avoid opening the doors for prolonged periods of time.
Turn On
1. Close the door(s) of the appliance.
2. Ensure the power switch is set to (0) and ltJrn on at the socket.
3. Switch on the Power (I). The current temperature within the apptiance is displayed.
Manual Defrost
The appliance will automaticaliy run a defrost cycle every six hours.
Note: The cycle starts from the time the appliance is inttialiy powered up.
To manually defrost the appliance:
1. Press and hold the DEFROST
2. The defrost cycle will start immediatety and the Defrost LED illuminates. The defrost wili last a maximum of 30 minutes.
<D Note: Starting a manual defrost also resets the automatic defrost timer.The next automatic defrost will start six
hours after lhe manual defrost has flnlshed.
3. Waste water is coliected in the waste water tray.
Cleaning, Care Maintenance
&
Switch off and disconnect from the power supply before cleaning.
Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmltJI residues.
Clean the door seal with water only.
Always wipe dry after cleaning.
Do not allow water used in cfeaning to run through the drain hole into the evaporation pan.
Take care when cleaning the rear of the appliance. Sharp edges can cut.
An agent or qualified technician musi carry out repairs ij required.
Cleaning the Condensar
Periodicaliy cleaning the condensar can extend the life of the appliance.
We recommend thai our agent or qualified technician dean the oondenser.
Troubleshooting
lf vour annliance develo1 s a fault. olease check the foliowina table betore makina a cali to vour retailer.
Fault
The appliance is noi
working
The appfiance lurns on,
but the temperaltJre is
tao high/low
®
button tor 5 seconds.
Probable Cause
The unii is noi switched on
Plug and tead are damaged
Fuse in the plug has blown
Power supply
Internal wiring tault
Too much ice on the evaporato,
Condensar blocked with dust
Actlon
Check the unii is plugged in correctly and
switched on
Cali your agent or qualified T echnician
Replace the fuse
Check power supply
Cali your agent or qualified T echnician
Defrost the appliance
Cali your agent or qualified Technician