Tristar KB-7145 Mode D'emploi page 6

Instruction manual
• When changing the gas cylinder and/or disconnecting the hose, it is
mandatory to close the valve of the gas cylinder.
• Replace the hose if it is damaged or if it becomes porous and in any
case before the expiry date printed on the side.
gaS ValVe aSSeMblY
• This assembly consists of an adjusting device with an incorporated
safety pilot, a burner with an electric igniter.
• The adjusting device can be set to 3 different positions:
Max Maximum cooling
MIN Minimum cooling
0 off Igniting position / burner gas supply closed
• The safety pilot automatically maintains the gas supply to the burner, as long
as it remains lit. It automatically shuts off the supply if the flame goes out.
ignition of the gaS burner
• Open the valve of the gas cylinder. Press the adjusting knob and hold it
in this position, then turn the knob anti-clockwise to Max.
• If the appliance has not been ignited for a long period, or if the gas
cylinder has been changed, there may be some air in the duct, so it
may fail to be ignited. It is necessary to check that the pilot is lit by
looking through the orifice at the top of the appliance. If the appliance
fails to be ignited, try it again after approximate 10 seconds.
• When the outside temperature is low, set the adjusting device to MIN
after a sufficient long cool-down period in MAX position.
to disconnect an appliance running on gas far from any source of ignition
• Shut off the gas cylinder or the pressure regulator. Turn the knob to the
OFF position.
6
Storing food
• Liquids to be stored in cool box shall always be placed in a closed vessel.
• The air circulation inside the appliance must not be obstructed.
never place hot food or drink in the appliance. never keep flammable
liquids and/or gases inside the cool box. Danger of explosion.
DefroSting – MeaSureS to be taken if the
aPPliance iS to be left unuSeD for a long
PerioD
The cool box must be defrosted regularly, in order to ensure that it
operates correctly. To defrost the cool box, disconnect it and remove all
food outside. If necessary, use a cloth soaked with hot water. After de-
icing, mop up the water with a dry clean cloth and clean the inside. If the
appliance is to remain unused for a extensive period, disconnect it and
remove all food outside. After de-icing, clean and dry the inside of the
appliance. In order to prevent unpleasant odor, leave the cover of the cool
box slightly open.
Measures to be taken after unused for a long period
If, after an extensive lay-up period, the cool box does not produce any
cooling, disconnect the appliance and turn it upside down for a few minutes
then turn it the right way up. After turn it over several times, reconnect it.
Maintenance
• Clean the appliance regularly with warm water, containing a detergent
if necessary.
• Never use an abrasive product. Dry the cleaned surfaces with a soft cloth.
• Use only clear water to clean the seal of the cover, and then coat the
seal with talcum powder.