EINHELL FREELEXO LCD BT+ Instructions D'origine page 45

11. Indicators on the charging station and troubleshooting
LED indicator (21)
Off
Lit up green
Flashing green
Lit up red
12. Indicators on the robot lawn mower and troubleshooting
Fault messages of the robot lawn mower in the LCD display (50)
Fault
No signal
Outside border
Battery error
Anl_FREELEXO_LCD_BT_plus_SPK13.indb 45 Anl_FREELEXO_LCD_BT_plus_SPK13.indb 45
GB
Description
- No power supply
- Ready for mowing
- Rechargeable battery (22) is
fully charged
- Perimeter wire (18) connec-
ted
- Perimeter wire (18) is se-
vered
- Rechargeable battery (22) is
charging
Possible cause
- Perimeter wire is not properly
connected
- No power supply
- The perimeter wire (18) is
severed
- Perimeter wire is not properly
connected
- The robot lawn mower is out-
side the mowing area
- There is a battery error on
the robot lawn mower
- The rechargeable battery
(22) does not charge up
- The rechargeable battery
(22) has reached the end of
its service life
- 45 -
Solution
- Check the power supply
- Inspect the perimeter wire (18) for a break
- Wait until the rechargeable battery (22) is
fully charged.
Remedy
Check whether the LED indicator (21) at the
charging station (19) is lit up green
- Make sure that the perimeter wire (18) has
been laid correctly and centrally under the
charging station (19)
- Check the position of the charging station
(19)
- Make sure that the perimeter wire (18) has
been laid correctly and centrally under the
charging station (19)
- Check that the robot lawn mower is inside
the mowing area
- Make sure that the rechargeable battery
(22) has been correctly fi tted
- Check whether the main switch (7) is ON
while the robot lawn mower is in the char-
ging station (19)
- Check the position of the charging station
(19) Replace the rechargeable battery
(22) if necessary.
14.01.2022 11:41:58 14.01.2022 11:41:58