tomado TDW6001B Manuel D'utilisation page 46

Problem
There are white stains on the dishes.
The dishes are not dry.
There are rust stains on the dishes.
46
• English
Possible cause
The amount of detergent is insufficient.
The selected program is not suitable for
the loaded dishes.
One of the spray arms is clogged.
The filters are clogged.
The filters are not placed correctly.
The water drain pump is clogged.
The amount of detergent is insufficient.
The level of rinse aid consumption is set
too low.
There is a high level of water hardness
and no salt is used.
The level of water hardness is set too
low, which affects the salt consumption.
The cap of the salt reservoir is not
closed correctly.
The selected program does not include
drying.
The level of rinse aid consumption is set
too low.
The appliance is unloaded too quickly
after the program is finished.
The stainless steel quality of the dishes
is insufficient.
The level of salt consumption is set too
high.
The cap of the salt reservoir is not
closed correctly.
Any spilled salt during filling of the salt
reservoir was not cleaned immediately.
The water supply is polluted.
Possible solution
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section Filling the
detergent reservoir.
Choose a suitable program. Refer to
section Programs.
Clean the spray arms. Refer to section
Cleaning the spray arms.
Clean the filters. Refer to section
Cleaning the filters.
Make sure that you correctly place the
filters.
Make sure that the water drain pump is
not clogged.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section Filling the
detergent reservoir.
Adjust the level of rinse aid
consumption. Refer to section
the level of rinse aid consumption.
Fill the salt reservoir. Refer to section
Filling the salt reservoir.
Adjust the level of salt consumption.
Refer to section Setting the level of salt
consumption.
Make sure that the cap of the salt
reservoir is closed firmly.
Choose a program that includes drying.
Refer to section Programs.
Adjust the level of rinse aid
consumption. Refer to section
the level of rinse aid consumption.
Wait a few minutes after the program
is finished before you unload the
appliance.
Make sure that you only clean
dishwasher-safe dishes in the appliance.
Adjust the level of salt consumption.
Refer to section Setting the level of salt
consumption.
Make sure that the cap of the salt
reservoir is closed firmly.
Make sure that you clean any spilled salt
immediately and run a full program to
prevent corrosion.
Do a check on the water supply.
Setting
Setting