TTI TGR1040 Manuel D'instructions page 3

Specifications apply after 30 minute warm-up in an ambient of 5°C to 40°C
FREQUENCY
Frequency Range:
Setting Resolution:
Display Resolution:
Accuracy:
Stability:
Phase Noise:
Residual FM:
(FM Off)
OUTPUT LEVEL
Output Level Range:
Setting Resolution:
Accuracy:
Harmonics:
Non-Harmonic Spurii:
Carrier Leakage:
Output Impedance:
Output Connector:
Output Switch:
FM MODULATION
Peak Deviation:
Setting Resolution:
Modulation Frequency:
Deviation Accuracy:
External Modulation
Frequency Response:
Distortion:
Input Impedance:
Input Connector:
2
10 MHz to 1000 MHz
1 kHz by direct keyboard entry, or in user-set increments of 1kHz to
999.999 MHz by rotary control or increment–decrement keys.
1 kHz
± 2 ppm over the temperature range 5°C to 40°C.
<1ppm/year ageing.
<−110dBc/Hz at 25 kHz offset, 500 MHz carrier.
Equivalent peak deviation in a 300 Hz to 3.4 kHz bandwidth:
12 Hz at 100 MHz carrier
25Hz at 500 MHz carrier
60 Hz at 1000 MHz carrier
–127dBm to +7dBm (0.1µV to 500 mV into 50Ω).
0.1dB (or 0.01µV to 1mV) by direct keyboard entry, or in user-set increments of
0.1dB to 100dB (or 0.01µV to 100mV) by rotary control or increment–decrement
keys.
Better than ± 2dBm, except for output levels <–70dBm at 500 -1000 MHz,
± 3dBm.
Typically <–25dBc, maximum –20dBc, any carrier frequency, output level ≤0dBm.
≤ – 60dBc at ≥ 8kHz offset.
≤ 0.5µV generated in a 50Ω load by a 2 turn 25mm diameter loop, 25mm from
the generator, with the output set to ≤ –10dBm into a 50Ω sealed load.
50Ω
TYPE N
RF OUT on-off switch with LED showing ON status.
0.5 kHz to 100 kHz.
0.5 kHz by direct keyboard entry, rotary control or increment–decrement keys.
Internal 1kHz; External 300 Hz to 50 kHz
<±15% of setting ± 0.5kHz, excluding residual FM, for 1 kHz modulation, internal
or 1Vrms external.
± 1dB from 300 Hz to 50 kHz relative to 1 kHz.
<2% total harmonic distortion at 1 kHz modulating frequency, 100 kHz deviation
and 500 MHz carrier.
100kΩ
BNC
Specifications