TTI TGR1040 Manuel D'instructions page 2

This low cost, synthesised RF signal generator features a wide amplitude range, low noise and
inherently good frequency stability. The generator also features internal and external FM. The
instrument can be operated manually via the front panel or remotely controlled via the RS232
(standard) or GPIB (optional) interfaces. It is suitable for FM radio receiver sensitivity
measurements, system gain measurements, oscillator substitutions, EMC/antenna/field strength
measurements and as a signal source for many other RF circuit and system development tasks.
In addition, the generator's low cost, ease of use and remote control make it eminently suitable
for most production and development applications where a basic, stable signal source is required.
Specifications
EMC
Safety
Installation
Connections
Front Panel Connections
Rear Panel Connections
Operation
General
Step Size
Setting Frequency
Setting Level
Modulation
Storing and Recalling Set-ups
Remote Operation
Address and Baud Rate Selection
Remote/Local Operation
RS232 Interface
Remote Commands
Maintenance
Appendix 1. Error Messages
Appendix 2. Factory Defaults
Instructions en Francais
Bedienungsanleitung auf Deutsch
Istruzioni in Italiano
Instrucciones en Español
Introduction
Table of Contents
2
5
6
7
8
8
8
9
9
10
10
10
11
11
12
12
12
12
19
22
23
24
25
46
66
86
1