TTI TGR1040 Manuel D'instructions page 23

*IST?
*OPC
*OPC?
*PRE <nrf>
*PRE?
*SRE <nrf>
*SRE?
*STB?
*WAI
Miscellaneous Commands
*IDN?
*TST?
*TRG
Calibration Specific Commands
See Service Manual for details of calibration specific commands.
The Manufacturers or their agents overseas will provide a repair service for any unit developing a
fault. Where owners wish to undertake their own maintenance work, this should only be done by
skilled personnel in conjunction with the service manual which may be purchased directly from
the Manufacturers or their agents overseas.
Cleaning
If the instrument requires cleaning use a cloth that is only lightly dampened with water or a mild
detergent.
WARNING! TO AVOID ELECTRIC SHOCK, OR DAMAGE TO THE INSTRUMENT, NEVER
ALLOW WATER TO GET INSIDE THE CASE. TO AVOID DAMAGE TO THE CASE NEVER
CLEAN WITH SOLVENTS.
22
Returns ist local message as defined by IEEE Std. 488.2. The syntax of
the response is 0<rmt>, if the local message is false or 1<rmt>, if the
local message is true.
Sets the Operation Complete bit (bit 0) in the Standard Event Status
Register.
This will happen immediately the command is executed because of the
sequential nature of all operations.
Query Operation Complete status. The syntax of the response is 1<rmt>.
The response will be available immediately the command is executed
because of the sequential nature of all operations.
Set the Parallel Poll Enable Register to the value <nrf>.
Returns the value in the Parallel Poll Enable Register in <nr1> numeric
format.
The syntax of the response is <nr1><rmt>
Set the Service Request Enable Register to <nrf>.
Returns the value of the Service Request Enable Register in <nr1>
numeric format. The syntax of the response is<nr1><rmt>
Returns the value of the Status Byte Register in <nr1> numeric format.
The syntax of the response is<nr1><rmt>
Wait for Operation Complete true. As all commands are completely
executed before the next is started this command takes no additional
action.
Returns the instrument identification. The exact response is determined
by the instrument configuration and is of the form <NAME>,<model>, 0,
<version><rmt> where <NAME> is the manufacturer's name, <model>
defines the type of instrument and <version> is the revision level of the
software installed.
The generator has no self test capability and the response is always
0 <rmt>
The generator has no trigger capability.
Maintenance