Publicité
EN
Safety and use guidelines
1.Read, understand and follow the following instructions before operating the hand jack.
2.Do not exceed the maximum lifting load as well as the maximum lifting height.
3.Use the jack only on flat and hard ground.
4.Do not get under the vehicle while it is being lifted by the jack.
5.Use the jack only in case of a tire change and in time of emergency.
6.Turn on the hazard lights in your vehicle, turn off the engine, lift the parking brake, lock the chassis by selecting a gear or putting it in PARKING position, and
place plugs on your wheels if you deem necessary before using the jack.
7.Lift your vehicle only from the points indicated by the manufacturer. Consult your vehicle's owner's manual for further instructions.
8.Follow your vehicle manufacturer's instructions for the tire change procedure.
9.Do not make any modifications to the tool.
10.Follow the above instructions carefully. If they are not followed, there is a risk of accident.
Before use
1.Check before each use for unusual appearance/functionality of your jack such as cracked welds, leaks, worn or missing parts.
2.Inspect the jack immediately if you believe it has been subjected to loads greater than those for which it was designed.
3.If the jack is showing wear and tear, it should be stopped until it has been inspected and repaired.
Instructions for use
1.Insert the jack lever into the hole in the lever system.
2.Check whether the treadle is in the correct position. To reduce wear on the jack, do not move the jack while under load.
3.To lift the load in question, use one hand to hold the base of the lever system using the lever, and with your other hand turn the lever clockwise from its end.
4.To lower the load use the above procedure, turn the lever counterclockwise at the end.
Care and maintenance
1.When not in use, store the jack in a safe place tightly closed.
2.Always keep your jack clean and the nuts and bolts always lubricated.
3.Store the jack with care in a place free of moisture and dust.
Technical data
Minimum height: 120 mm
Maximum height: 395 mm
Weight: 3.5 kg
Maximum load: 2 Ton
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes signif-
icantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also
concern other models of the manufacturer's product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury
or death. The manufacturer and the importer shall not be liable for injuries and damages resulting from the use of non-conforming equipment.
2
WWW.NIKOLAOUTOOLS.GR
Publicité
