Télécharger Imprimer la page

Poulan Pro PBA19542LT Manuel De L'opérateur page 7

Publicité

INSTALL SEAT (See Fig. 2)
Adjust seat before tightening adjustment knob.
Remove adjustment knob and flat washer securing
seat to cardboard packing and set aside for assembly
of seat to tractor.
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
Place seat on seat pan so head of shoulder bolts are
positioned over the large slotted holes in pan.
Push down on seat to engage shoulder bolts in slots
and pull seat towards rear of tractor.
Pivot seat and pan forward and as sem ble adjustment
knob and flat washer loosely. Do not tighten.
Lower seat into operating position and sit in seat.
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way
down.
Get off seat without moving its ad just ed position.
Raise seat and tighten adjustment knob securely.
SEAT PAN
FLAT WASHER
ADJUSTMENT
KNOB
ASSEMBLY
SEAT
SHOULDER
BOLT
02464
FIG. 2
CHECK BATTERY (See Fig. 3)
Lift seat pan to raised position.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in MAINTENANCE section of this
manual for charging instructions).
SEAT PAN
NOTE: You may now roll or drive your tractor off the skid.
Follow the ap pro pri ate instruction below to remove the
tractor from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op-
er a tion section for location and function of
con trols)
Press lift lever plunger and raise attachment lift lever
to its highest po si tion.
Release parking brake by de press ing clutch/brake
ped al.
Place gearshift lever in neutral (N) po si tion.
Roll tractor forward off skid.
Remove banding holding the deflector shield up against
tractor.
7
LABEL
FIG. 3

Publicité

loading