Publicité
Les langues disponibles
Les langues disponibles
GB
b) Align the holes on support leg into the holes on the machine body, and fasten
the support leg on the machine body by bolts and nuts. (Fig. 3)
Operation
Warning!
Before operating the log splitter, the Bleed Screw (13) Fig. 4, should be
loosened by some rotations until air can go in and out of the oil tank
smoothly.
Air flow through the Bleed Screw hole should be detectable while the log
splitter is under operations.
Before moving the log splitter, make sure the Bleed Screw is tightened to
avoid oil leaking from this point.
Failed to loosen the bleed screw will keep the sealed air in hydraulic system being
compressed after being decompressed, such continuous air compression and
decompression will blow out the seals of the hydraulic system and cause
permanent damage to the log splitter.
10
Publicité
