Chain Oil System - Ryobi EXPAND-IT ATTACHMENTS RY40006 Manuel D'installation

TO INSTALL/REMOVE BATTERY PACK
See Figure 5.
WARNING:
Always remove battery pack from your tool
when you are assembling parts, making adjust-
ments, cleaning, carrying, transporting or when
not in use. Removing battery pack will prevent
accidental starting that could cause serious
personal injury.
NOTE: To avoid serious personal injury, always
remove the battery pack and keep hands clear of
the lock-out button when carrying or transporting
the tool.
To install:
 Place the battery pack in your chain saw. Align
raised rib on battery pack with groove in chain
saw's battery port.
 Make sure the latch on bottom side of bat-
tery pack snaps in place and that battery
pack is secured in chain saw before beginning
operation.
WARNING:
Make sure the latch on the battery pack snaps
in place and the battery pack is fully seated and
secure in the power head battery port before
beginning operation. Failure to securely seat
the battery pack could cause the battery pack
to fall out, resulting in serious personal injury.
To remove:
Locate latch on bottom of battery pack and depress
both sides to release the battery pack from the
chain saw.
NOTICE:
When placing battery pack in your chain saw,
be sure raised rib on battery pack aligns with
groove in chain saw's battery port and latches
snap in place properly. Improper assembly of
battery pack can cause damage to internal
components.
For complete charging instructions, see the opera-
tor's manuals for your battery pack and charger.
OPERATION

CHAIN OIL SYSTEM

See Figure 6.
NOTICE:
Remove battery pack from unit. Fill oil tank with
bar and chain lubricant (not provided) before
starting the chain saw. Failure to lubricate the
chain will cause damage to the bar and chain.
 Use bar and chain lubricant (not provided). That
is formulated to perform over a wide tempera-
ture range with no dilution required.
NOTE: Do not use dirty, used or otherwise con-
taminated oils. Damage may occur to the bar or
chain.
 Carefully pour the bar and chain oil into the tank.
 Check and fill the oil tank when battery is
recharged, or as needed.
NOTE: It is normal for lubricant to seep from the
saw when not in use. To prevent seepage, empty
the oil tank after each use. When storing the unit
for a long period of time (three months or longer) be
sure the chain is lightly lubricated; this will prevent
rust on the chain and bar sprocket.
14 - English
BATTERY
PACK
LATCH
BATTERY
PORT
Fig. 5
Fig. 6