Zoofari AZ-9671 Notice D'utilisation page 13

Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following instructions for
use carefully.
Use the product only as described and only
for the given areas of application. Store these
instructions for use carefully. When passing the
product on to third parties, please also hand
over all accompanying documents.
Package contents
1 x car seat
1 x instructions for use
Technical data
Dimensions:
Lying surface approx. 45 x 45cm (W x L)
Side walls each approx. 45 x 23.5cm (W x H)
Back side length approx. 46.5 x 58cm (W x D)
Date of manufacture (month/year):
08/2021
Intended use
This product was developed solely as a pet
accessory for personal use and is not to be used
for commercial purposes.
Safety information
• Do not use any sharp-edged or pointy objects
on the product.
• Check the product for damage or wear before
each use. The product must only be used if it is
in perfect condition!
• Only use the product for its intended purpose.
• Make sure that your dog does not chew on
the product.
• Do not make any modifications to the product.
• When installing the product, make sure
that you do not cover any air bags. Consult
with your respective vehicle manufacturer if
necessary.
Fastening the product to the
back seat
The product comes with two straps with buckles
for fastening. You only require the upper strap to
fasten it to the back seat.
1. Remove the packaging and unfold the
product (1).
2. Place the product on the back seat of your car.
3. Put the seat anchor (1a) between the backrest
and the seat (Fig. B).
4. Open the upper buckles (1b) (Fig. C) and
wrap them around the brackets on the
headrests of the back seats.
5. Close the buckles and pull on the end of the
strap (1c) until the strap is positioned firmly
against the headrest (Fig. C).
6. Fold out the sides of the product and close the
corners with the hook and loop fasteners (1f)
(Fig. A).
Note: you do not need the lower strap to fasten
the product to the back seat.
7. Secure your dog with a suitable strap (not
included in the package contents).
Fastening the product to the
passenger seat
Use both straps to fasten the product to the
passenger seat.
1. Remove the packaging and unfold the
product (1).
2. Place the product on your vehicle's passenger
seat.
3. Put the seat anchor (1a) between the backrest
and the seat (Fig. B).
4. Open the upper buckles (1b) (Fig. C) and
wrap them around the brackets on the
passenger seat headrest.
5. Close the buckles and pull on the end of the
strap (1c) until the strap is positioned firmly
against the headrest (Fig. C).
6. Open the second buckles and wrap them
around the backrest of the passenger seat.
7. Close the buckles and pull on the end of the
strap (1c) until the strap is positioned firmly
against the backrest of the passenger seat.
GB 13