NAD C 320BEE Manuel D'installation page 9

PRESS IN AND LIFT TAB TO REMOVE
BATTERY COVER OUT FROM RECESS
TROUBLESHOOTING
PROBLEM
NO SOUND
NO SOUND ONE CHANNEL
WEAK BASS / DIFFUSE STEREO IMAGE
REMOTE CONTROL HANDSET
NOT WORKING
POWER/PROTECTION LED TURNS RED
DURING OPERATION
All manuals and user guides at all-guides.com
PLACE BATTERIES INTO OPENING. ENSURE
THE CORRECT POLARITY IS OBSERVED
CAUSE
• Power AC lead unplugged or power not
switched on
• Tape 1 Monitor selected
• Mute on
• Rear Pre-out/Main-in amp links not fitted
• Headphones inserted
• Balance control not centered
• Speaker not properly connected or damaged
• Input lead disconnected or damaged
• Speakers wired out of phase
• Batteries flat, or incorrectly inserted
• IR transmitter or receiver windows obstructed
• IR receiver in direct sun or very bright ambient
light
• Amplifier has overheated
• Overall impedance of loudspeakers too low
REPLACE BATTERY COVER BY ALIGNING AND
INSERTING THE TWO TABS INTO THE HOLES.
PRESS BATTERY COVER INTO PLACE UNTIL IT
'CLICKS' CLOSED
SOLUTION
• Check if AC lead is plugged in and power
switched on
• De-select Tape 1 Monitor mode
• Switch off Mute
• Fit links
• Disconnect headphones
• Center Balance control
• Check connections and speakers
• Check leads and connections
• Check connections to all speakers in the system
• Check or replace batteries
• Remove obstruction
• Place unit away from direct sun, reduce amount
of ambient light
• Turn amplifier off, make sure ventilation slots on
top and bottom of amplifier are not blocked.
After amplifier has cooled down, turn back on
• Ensure the overall loudspeaker impedance is not
below 4 ohms
9