Table des Matières
Publicité
Grounded
Outlet
Grounding
Pin
(United States, Mexico and Canada)
Figure 4
Toma
corriente
con polo
de tierra.
Terminal
de tierra
Figure 4a
Prise de
courant
avec mise
à la terre
Broche de mise
à la terre.
Figure 4b
Page -18 -
Instructions for connection to the power
This product must be grounded. If it should malfunction
or breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of
electrical shock. This product is equipped with a cord
having an equipment-grounding conductor and ground-
ing plug. The plug must be inserted into an appropriate
oulet that is properly installed and grounded in accor-
dance with all local codes and ordinances.
Grounded
WARNING: Improper connection of the equip-
ment-grounding conductor can result in a risk of
Outlet
electric shock. Check with a qualified electrician
Box
or service person if you are in doubt as to whether
the outlet is properly grounded. Do not modify the
plug provided with the product - if it will not fit the
outlet, have a proper outlet installed by a qualified
electrician.
This product is for use on a nominal 120 volt circuit and
has a grounding attachment plug that looks like the plug
illustrated in Fig. 4. Make sure that the product is
connected to an outlet having the same configuration as
the plug. No adaptor should be used with this product.
WARNING: To prevent possible electric shock,
protect the machine from rain. Keep the machine
in a dry building.
WARNING: To prevent possible electric shock,
always use a 3-wire electrical system connected
Tapa del
to the electrical ground. For maximum protection
toma
against electrical shock, use a circuit that is
corriente
protected by a ground fault circuit interrupter.
con polo
Consult your electrical contractor.
de tierra.
WARNING: Do not cut, remove or break the
ground pin. If the outlet does not fit the plug,
consult your electrical contractor.
WARNING: Have worn, cut or damaged
cords replaced by an authorized service person.
Use only an approved extension cord with three
conductors, a plug with three terminals, and a
connector body with three holes. The machine has a
power cord with wire size 14 AWG (AWG means
American Wire Gauge).
Boîte de
WARNING: If you use an extension cord,
sortie
use an extension cord with minimum wire size
12 AWG. Do not use an extension cord longer
mise à la
than 50 feet. Do not join two extension cords.
terre
CLARKE TECHNOLOGY Operator's Manual - MP-1800 Marble Polisher 120V
120 VOLT MACHINES
supply and the electrical ground.
EXTENSION CORDS
Publicité
Table des Matières
