Publicité
Les langues disponibles
Les langues disponibles
similar applications such as: staff kitchen areas in shops,
offices and other working environments; by clients in
hotels, motels and other residential type environments; farm
houses, bed and breakfast type environments.
- The appliance is not intended to be operated by means
of an external timer or separate remote-control system.
- Before every use, unroll the power cord.
- Use original spare parts and accessories only.
- Do not subject the product to strong impacts, serious
damages may result.
-
Do not connect the electric plug since the installation is not complete.
-
Do not leave the appliance unattended while it is running. Unplug after each use.
-
Unplug the unit by pulling the plug and not the power cord.
-
Do not immerse product in water or other liquids and avoid splashing liquids reach the unit.
-
Before carrying out any cleaning, disconnect the unit from the electrical outlet.
-
Before each use, unroll the power cord. Do not insert anything through the protection grids.
-
Do not obstruct in any way the protection grids.
-
Place on solid and stable surfaces and away from windows or drafts.
DESCRIPTION G50034
1 Front protection grid
4 Screws for rear fan stop
7 Oscillation pin
10 Control panel
13 Tilt knob
16 Front grid fixing screw
ASSEMBLING
The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the
maximum safety, perform the installation completely before operating.
1) To mount the motor housing (8) over the base (11), follow the instructions:
a.
Align the holes on body and pole, and insert Screw 2 (17) in the lower holes. That screw has to be
inserted from right to left, and must be inserted completely, until the final part of the screw, that is
square-shaped, is entered in the hole of the neck (9) of the motor housing.
b.
Insert Screw 1 (14) in the left hole on the head side, and screw it.
c.
Fix the head screwing the knob (18)
d.
Slant the head in the desired position and tighten the knob (13)
2) Place the rear grid (5) near the front of motor housing (8) with the metal handle (7) facing upwards. Fit the
holes present in the central part of the grid with the holes on the housing (8) and lock the two parts with the
4 screws (4).
3) Insert the fan (3) onto the shaft (6) and secure the fixing screw of the fan (2) in its hole.
4) Remove the fixing screw (16).
5) Place the front grid (1) in front of the rear grid (5) matching the holes on the grids.
6) Close the locking pins and fasten the two grids tightening the securing screw (16) previously removed. The
fan is now correctly assembled.
GENERAL INFORMATION
2 Fan stopper
5 Rear protection grid
8 Motor housing
11 Base
14 Screw 1
17 Screw 2
3 Fan
6 Drive shaft
9 Inclination pin
12 Handle
15 Base top
18 Fixing knob
9
Publicité
