Powerplus POWDP15680 Mode D'emploi page 52

9.9 Function mode selector (4) (Fig. 9)
Hammer/ drill mode:
Drill in masonry, concrete and natural stone.
Don't use the hammer drill function for ceramic tile or others material cannot
withstand impact energy.
Chiselling mode:
Chisel in masonry, concrete and natural stone.
Drilling mode:
Drilling in wood, synthetic materials and metal.
Chisel Rotation:
Non-working position used only to rotate flat chisel into the desired position.
Important! Hammer drilling requires a low pressure. Too much pressure will
place unnecessary load on the motor. Check the drill bits regularly. Re-
sharpen or replace blunt drill bits.
Do not use a seperate chuck with SDS connector in combination with the
hammer/hammer drill function!
WARNING! Do not select the operating mode when the tool is running.
WARNING! Always wait until the machine has come to a complete standstill
before changing the drilling, hammer/drilling function.
9.10 Overload Clutch
If the tool insert becomes caught or jammed, the drive to the drill spindle is interrupted.
Because of the forces that occur, always hold the power tool firmly with both hands and
provide for a secure stance.
If the power tool jams, switch the tool off and loosen the tool insert. When switching the tool on
with the drilling tool jammed, high reaction torques can occur!
WARNING! As soon as the power tool jams, switch the tool off immediately.
This will help prevent premature wear of the tool.
10 OPERATION
10.1 Switching ON/OFF (Fig. 10)
▪
Switching on:
▪
Switching off:
Note: The trigger switch can be used as a variable speed control
mechanism.
Copyright © 2022 VARO
Press the operating switch (5).
Release the operating switch (5).
POWDP15680
P a g e | 10
EN
www.varo.com