Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
7. Reinstall the nozzles to the spray bar. Tighten securely.
Align the nozzle opening as shown in Figure 5.
NOTE: Make sure the groove on the face of the nozzle is
parallel to the spray bar.
NOTE: If the nozzles are not cleaned or aligned correctly
the spray bar will not rotate properly and it will not clean
as intended and may have a severe vibration.
WARNING:
If the surface cleaner experiences severe vibration,
STOP using immediately. Continuing to use the surface
cleaner may damage the shroud and result in serious
injury.
NOTE: If your spray pattern begins to change, it could
mean that the nozzles are worn and they will need to be replaced.
NOTE: If the nozzles continue to get clogged, you may want to consider adding an in-line filter. You
can contact us at +1 (866) 870-9930 or email us at Support@surfacemaxx.com for more details.
HOW TO CHANGE NOZZLES
This surface cleaner is equipped with 1.5 sized nozzles. If you want to change out the nozzles,
follow the nozzle removal steps found in the "Maintenance" section of this manual.
Surface Cleaner Nozzle Sizes
Pressure Washer
PSI
3000
3600
4000
4000
4500
*All nozzles are 25-degrees.
Note: Pressure washer PSI and GPM can vary by
manufacturer.
Pressure Washer
Recommended
GPM
2.3
2.5
3.0
3.5
4.2
Spray Bar
Figure 5
Nozzle Size
25013*
25013*
25015*
25020*
25020*
5
Nozzle Opening
After tightening securely,
nozzle opening should be
pointed in same direction
as spray bar
Scan to find your
perfect nozzle size:
*Don't forget to
divide the nozzle
number by 2 for
surface cleaners!
www.surfacemaxx.com
Publicité
