SAFETY INSTRUCTIONS
WARNING:
When using this product basic precautions should always be followed, including but not limited to
the following:
1. Observe the safety instructions of your pressure washer.
2. The surface cleaner must not be used by children.
3. Only trigger the gun of the pressure washer if the surface cleaner is on the surface to be cleaned.
4. Keep all persons/animals clear of the immediate vicinity of the cleaning head.
5. To avoid serious injury, NEVER place hands near or under the surface cleaner.
6. Turn off the pressure washer and relieve the pressure when examining or changing the surface
cleaner and after the completion of the cleaning operation.
7. Maximum water temperature allowed is 212 °F/ 100 °C. Follow the instructions for your pressure
washer.
CAUTION:
1. The surface cleaner is not suited for scouring or scrubbing.
2. Do not run over freestanding corners.
3. Test the surface cleaner in an inconspicuous area.
4. Not to be used on vertical surfaces.
INTENDED USE
1. The surface cleaner can be used with electric and gas pressure washers from 2800 to 4500 psi.
2. Use on horizontal surfaces like concrete driveways, patios, sidewalks, etc.
RECOMMENDATION
1. It is recommended that a high pressure filter be purchased to prevent the nozzles from getting
clogged.
ASSEMBLY
1. The surface cleaner comes completely assembled and
ready for use.
2. Attach the surface cleaner's 1/4-in. quick connect plug
into the end of the pressure washer wand (See
Figure 1).
3. Connect hose to the pressure washer and start
pressure washer as described in its Owner's Manual.
CAUTION:
1. Risk of injury can occur if the surface cleaner 1/4-in. quick connect plug is not properly inserted
into the quick connect coupler. Make sure you hear a "click" sound when attaching the 1/4-in.
quick connect plug to the quick connect coupler.
2. Pull the surface cleaner to make sure it is seated properly before operating your unit.
Figure 1
3
Quick Connect
Coupler
1/4-in. Quick
Connect Plug
www.surfacemaxx.com